Night and day difference in flight and responsiveness between 2 and 3 cell li-po on my little 98mm with 1106 6000kv t-motors and 2.5 inch props.
And the tattu greatly out performs the hyperion graphene even though its 25% more capacity and not much heavier I think that comes down to a slightly lower c rating and longer leads that seem like they are thinner 16awg than the tattu 16awg wire. From these i get about 35A peak draw.
This Tattu 450ma 3cell is insane... 40A peak draw and I always get 450-470ma out of it.
I know based on the c rating I am pulling more than I should and the battery does get warm but these little things are super impressive.
Even the 2cell performs well and I can pull 16-20A at the start of the pack but it drops of quite quickly and I don't get the RPM required from 2 cell for my motor kv to make my quad super responsive but I think if I put some 1104 7500-9000 of motors on it these 2cell would he a dream too.
Will be getting more of these... well done tattu
Cleaned up the bench a bit. Quad flies, quite nicely, working through camera selections and mounts. I keep flipping between a tiny AIO, and a Foxeer Monster.. #quadcopter#miniquad#drone#microquad @flybyacademy
Ultra light power bank for mini quad
“GAONENG 6s 6500mAh lipo”
Only 800g and as a external power bank, it can change over 10 no. of 4s 850mAh for your 3 inch quad
Enjoy all day flight with GNB - Gaoneng Battery Limited Ultra light power bank
#gnbbattery#gaonengbatteries oneng #fpvbattery
Finally going to cut out the stripped motor bolts and get this one flying again. Does anyone else have terrible luck with the stock M2 bolts these things tend to come with? From now on I'm just using socket head from the start.